Rocketfish RF-HTS120 Merkblatt

 ENGLISH 10-1240

4  Plug the power cords of any devices that require constant 

power, such as a DVR/PVR, or devices that you wish to use while 
the primary device is powered off, into the Always-on outlets of 
the Power Manager. 

5  Connect the incoming coaxial cable source (i.e., the cable jack 

on the wall or incoming satellite line) to the coaxial jack marked 
IN on the Power Manager.

6  Connect a separate coaxial cable from the coaxial jack marked 

OUT on the Power Manager to the coaxial input jack of the 
cable/satellite set-top box.

7  Connect the incoming Ethernet (RJ45) line to the Network line 

jack marked IN on the Power Manager.

8  Connect a separate Ethernet cable from the Network line jack 

marked OUT on the Power Manager to the corresponding input 
jack on the device (i.e., Blu-ray player, set-top box, DVR, etc.).

9  Connect the incoming phone (RJ11) line to the Phone line jack 

marked IN on the Power Manager.

10  Connect separate phone line cables (up to two) from the Phone 

line jacks marked OUT on the Power Manager to the 
corresponding input jacks on the devices. 

11  After all devices have been properly plugged into the Power 

Manager and powered on, when you power the primary device 
that is plugged into the Master outlet on and off, the secondary 
devices that are plugged into the Master-controlled outlets will 
automatically power on and off. Devices that are plugged into 
the Always-on outlets will not be controlled by the primary 
device, and must be powered on and off separately as desired.

 

Note: Should the Master-controlled outlets not power on and 
off as described when the primary device plugged into the 
Master outlet is powered on and off, it is possible that the 
primary device draws too much current while in the OFF or 
STANDBY mode. In the event this should occur with your 
equipment, try plugging a different primary device into the 
Master outlet.

•  Load rating: 15 amps

•  Line voltage: 125V AC @ 60 Hz

•  Surge protection: 3 lines (L-N / L-G / N-G)

•  Maximum surge current: 225,000 amps

•  Maximum energy dissipation: 4,650 joules

•  Clamping voltage: L-N / L-G / N-G = 400 volts

•  EMI/RFI noise filtering: Up to 80 dB

•  Standby power consumption: 1.82 watts

•  USB port power output: 5V DC, 1.0 amp

• UL-1449 certified

•  RISK OF ELECTRIC SHOCK–Use only in dry locations and only 

indoors.

•  DO NOT plug into another relocatable power tap. 

•  DO NOT “daisy chain” surge protectors.

•  DO NOT use with aquarium equipment. 

•  DO NOT use if correctly grounded outlets are not available. 

•  DO NOT install this device if there is not at least 30 feet 

(10 meters) or more of wire between the electrical outlet and 
electrical service panel.

This device complies with Part 15 of the FCC Rules. Operation is 
subject to the following two conditions:

(1) this device may not cause harmful interference, and

(2) this device must accept any interference received, including 
interference that may cause undesired operation.

Changes or modifications not expressly approved by the party 
responsible for compliance could void the user’s authority to 
operate the equipment.

This Class B digital apparatus complies with Canadian ICES-003.

Note: These limits are designed to provide reasonable protection 
against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency 
energy and, if not installed and used in accordance with the 
instructions, may cause harmful interference to radio 
communications. However, there is no guarantee that interference 
will not occur in a particular installation.

If this equipment does cause harmful interference to radio or 
television reception, which can be determined by turning the 
equipment off and on, the user is encouraged to try to correct the 
interference by one or more of the following measures:

Reorient or relocate the receiving antenna. Increase the separation 
between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from 
that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

This Class B digital apparatus complies with Canadian ICES-003.

See included warranty sheet, visit www.rocketfishproducts.com or 
call 800-620-2790 for additional connected equipment and product 
warranty information or for customer service.

© 2011 BBY Solutions, Inc., All Rights Reserved.
Distributed by Best Buy Purchasing, LLC
7601 Penn Avenue South, Richfield, MN USA 55423-3645
ROCKETFISH is a trademark of BBY Solutions, Inc. All other products and 
brand names are trademarks of their respective owners.