Rimage Auto Printer RAS10 Benutzerhandbuch

6  

110656_H 

You can load up to 100 discs per carousel bin. You may load discs in the bins before installing 
the carousel. 

When the carousel is installed in the AutoPrinter, discs can be installed one bin at a time by 
following the procedure below. 

1. Press 

the 

operator button to rotate the carousel and place a bin in position to load blank 

discs. 

2.  Remove any completed discs from the carousel bins.  

3. Place 

blank discs in bins 1–3 of the carousel. The AutoPrinter will pick discs from the next 

bin once the first bin is empty. Bin 4 is only used for outputting completed discs. 

- 

Important! Place the discs into the bins with the recording side facing down. 

# 

Tip: Hold the discs by the outer edge so you do not put fingerprints on either the top or 
the bottom surface of the discs. Fingerprints on the top of the disc can affect printing 
quality. Rimage recommends wearing lint free gloves.  

4.  Repeat steps 1–2 until the required bins are filled. 

1. Press 

the 

operator button to rotate the c

2. Remove 

the 

discs from the desired bin. 

arousel and place a bin in position to unload discs. 

After the AutoPrinter starts picking discs from bin 2 or 3, it continues picking discs from that bin 
until the AutoPrinter is powered off, or the AutoPrinter is reset. 

1.  To reset the AutoPrinter to start picking discs from bin 1, lift the carousel up and down so the 

carousel present indicator light turns on and off. 

2. Add 

discs to bin 1. The next print job will start picking from bin 1. 

Printing preferences allows you to set and run your AutoPrinter to produce the best possible label 
on your discs. Refer to your Everest Printer User Guide or PrismPlus Printer User Guide for 
specific printing preferences instructions.