RGB Spectrum Digital Recording and Streaming System DGy 201x Benutzerhandbuch
C O M M U N I C A T I O N S S E T U P
Ethernet Control
350-9047 v3.0.1
DGy Model 201x User’s Guide
135
. . . . .
IP ADDRESS SETUP
. . . . . . . . .
VIA SERIAL PORT
Use the following steps to change the DGy 201x IP address using the
serial port:
serial port:
1.
section in
section on page 131 of this chapter.
2.
In the Hyperterminal window, type:
IPADDR
... and press ENTER.
DGy 201x responds with the current IP address. Make a note of
the address before proceeding with the next step.
the address before proceeding with the next step.
3.
Type
IPADDR
followed by a space, and the new IP address (as
provided to by the network administrator).
S
Example: If the new IP address is 192.168.1.190, type:
IPADDR 192.168.1.190
... and press ENTER.
4.
DGy 201x responds with the following message:
The system must be restarted for your changes to
take effect. Do you want to restart the system
(y/n)?
~
Press y to restart DGy 201x and use the newly
assigned IP address.
assigned IP address.
~
Press n to retain the current IP address, and discard the
new address.
new address.
5.
After the DGy 201x restarts, confirm the new setting by typing
the command
the command
IPADDR
. If the DGy 201x has accepted the
command, it responds with the new IP address just entered.
Once IP address has been set, connect the PC to the DGy 201x using
Ethernet. In Chapter 2, refer to the
Ethernet. In Chapter 2, refer to the
section for
instructions.