RGB Spectrum Digital Recording and Streaming System DGy 201x Benutzerhandbuch
I N S T A L L A T I O N A N D S E T U P
Installation
350-9047 v3.0.1
DGy Model 201x User’s Guide
18
. . . . .
6.
Select a Control Method — Control of the DGy can be through
either RS-232 serial or Ethernet connection. See
either RS-232 serial or Ethernet connection. See
for details on establishing communication between a PC and the
DGy 201x.
DGy 201x.
~
Serial Control — To control DGy 201x using a terminal
emulation program (such as Hyperterminal or
Procomm), connect the COM port of the device to the
DGy 201x RS-232 Port. This enables DGy 201x control
through ASCII commands. For information on DGy
201x commands refer to the
emulation program (such as Hyperterminal or
Procomm), connect the COM port of the device to the
DGy 201x RS-232 Port. This enables DGy 201x control
through ASCII commands. For information on DGy
201x commands refer to the
A straight through cable (typically 9-pin male-to-female
with one-to-one wiring) is required. For information on
RS-232 connection parameters refer to the
with one-to-one wiring) is required. For information on
RS-232 connection parameters refer to the
section in Appendix A (page 129).
Launch Hyperterminal or other terminal emulator
software and set the communication parameters to:
software and set the communication parameters to:
• 115,200
Baud
• 8
Bits
•
1 Stop Bit
• No
Parity
•
XON/XOFF Flow Control
For information on setting up a Hyperterminal see
Appendix B,
Appendix B,
on
~
Ethernet Control — To control the DGy 201x over a
network, connect an Ethernet cable from the LAN to the
DGy 201x’s 100/1000 Base-T Ethernet Port. This
method allows use of a Telnet session or a standard
web browser to access DGy 201x’s internal Web
Control Panel. Ethernet is also ideal for controlling
multiple DGy 201x recorders.
network, connect an Ethernet cable from the LAN to the
DGy 201x’s 100/1000 Base-T Ethernet Port. This
method allows use of a Telnet session or a standard
web browser to access DGy 201x’s internal Web
Control Panel. Ethernet is also ideal for controlling
multiple DGy 201x recorders.
Note
A PC can be connected directly to the DGy 201x
Ethernet Port without being connected to a network.
For this direct-connect method, use an Ethernet hub
or crossover cable. In Appendix A, refer to the
Ethernet Port without being connected to a network.
For this direct-connect method, use an Ethernet hub
or crossover cable. In Appendix A, refer to the
section on page 128 for pinout
details.