RGB Spectrum Digital Recording and Streaming System DGy 201x Benutzerhandbuch

. . . . .

The DGy Control Panel will lose communication with the DGy 
201x as soon as the restart procedure begins. If the IP address 
of the DGy 201x has been changed, the new network settings 
must be used to reconnect to it. After the connection has been 
dropped, the WCP or Telnet session must be restarted.

The current serial port baud rate is displayed and can be 
changed in this section of the Systems tab. Available baud 
rates range from 9600 baud to 115,200 baud. It is 
recommended that the default baud rate, 115k baud, be used. 
To change the serial port parameters:

~

Use the pull-down 

menu to set the baud rate 

for the system’s RS-232 serial port. The default value is 
115,200 baud.

~

Check the 

 box to enable echo.

The DGy 201x uses an internal real-time clock to time stamp the 
recordings. 

The DGy system time and date can be set manually or 
synchronized to the PC controlling the DGy 201x.

•

In the 

 section:

~

Click 

to load the PC’s local time into the DGy 

201x’s temporary clock register.

~

Use the

 and 

 up/down selectors to adjust the 

date and time as necessary.

~

Identify the Time Zone the DGy 201x is located in by 
using the drop down 

box.

~

Click

 to upload the new time setting into DGy 

201x’s active clock register.

~

Specify the time zone the DGy 201x is in by using the 
drop down 

box.

~

Use the entry boxes to manually set the 

 and 

Time.

~

Click

 to upload the new time setting into DGy 

201x active clock register.

When 

 is clicked, a Restart Warning is displayed. 

.) Click 

 to cancel the reboot and go 

back to the old time and date values; click 

 to restart 

the DGy 201x using the time and date values. A