Prozone Pool Products CSS10 Benutzerhandbuch

3

 
 

CSS10 Box 

7S10T-42IA-P19 

1

 

Salt Generator Bracket 

202199 

1

 

Salt Generator Cell 

600211 

1

 

Saddle Clamp Assembly 

201155 

2

 

Injector 

600002 

1

 

Plastic Clamp (black) 

20185 

4

 

¾” Metal Hose clamp 

20067 

4

 

¼” Braided Hose 

20260 

120 inches

 

¼” Braided Hose 

 

 

(Cell Maintenance) 

20260 

24 inches

 

¾” Clear Hose 

20264 

120 inches

 

Check Valve (1/4”  by ¼”) 

20214 

1

 

White ½” by 3” PVC Pipe 

20314 

1

 

Gasket, Saddle Clamp 

400078 

2

 

Gasket, Saddle Clamp, Barb 

400076 

2

 

Gasket, Saddle Foot 

400018 

4

1.   Your CSS-10 must be installed in accordance with the installation instructions and the Figures/Diagrams provided in this manual.

2.  To have both your Pump system, and the CSS-10 operate properly together as a unit you should wire the two systems together.

3.  The Salt Cell MUST be mounted vertically.

4.  Use only the power cord (DC Voltage) provided with the Ozonator/Salt Generator System to power up the Salt Cell.

1.  You should test the salt level of your pool before calculating the salt requirement.

2.  If a Salt test is not performed you may find later that too much salt will have been added - the Chlorinator may not perform as intended.

3.  If the pool has been treated with other forms of Chlorine – for instance Sodium Chloride – you may already have salt content

1.  Always balance the pH, total Alkalinity and Calcium hardness, otherwise corrosive or scaly conditions may result, which will lead to equipment  

   inefficiency or damage. Unbalanced water may cause staining and mineral deposits, chlorine effectiveness may decrease, and bathers may 

  experience discomfort.

2.  Regular testing of the pool waters is recommended. A Free Chlorine level of 0.5ppm (parts per million) to 1.5ppm should be maintained.

3.   DO NOT USE  Copper or Bromine based Algaecide products in your pool when the CSS-10 is installed. 

4.   Prozone recommends the pool pump and Salt Generator (see safety note above),  for a minimum of 8 to 12 hours a day. Actual run time 

  will be affected by the chlorine demand from the environment or bathers.

7.   WARNING:  Always disconnect automatic pool cleaners before adding salt which must be fully dissolved before turning on the 

8.   Plaster Pools:  Do not start system until plaster has set for two weeks.

9.   WARNING:  Baquacil (Biguanide Pools)  must be drained and refilled with fresh water prior to using the CSS-10.   

10. Read the entire Owner’s Manual.  Additional advice can be obtained from a pool installation professional or from a Prozone sales representative   

  (sales@prozoneint.com) or visit our website at www.prozoneint.com.