Proxim AP-4000 Benutzerhandbuch

Symptoms and Solutions

6. Perform the 

 in this guide. This will reset the unit to “DHCP” mode. If there is a 

DHCP Server on the network, the DHCP Server will assign an IP Address to the AP.

1. Make sure you are using a compatible browser: 

–

Microsoft Internet Explorer 6 with Service Pack 1 or later

–

Netscape 7.1 or later

2. Make sure you have the proper IP address. Enter your Access Point’s IP Address in the browser address bar, similar 

to this example: 
               http://192.168.1.100 
When the Enter Network Password window appears, leave the User Name field empty and enter the HTTP 
password in the Password field. The default HTTP password is “public”.

3. Use the CLI over the serial port to check the IP Access Table, which can be restricting access to Telnet and HTTP.

1. Verify that the HTML Help files are installed in the default directory:

              C:\Program Files\ORiNOCO\AP4xxxx\HTML\
If the Help files are not located in this folder, contact your network administrator to find out where the Help files are 
located on your server. 

2. Copy the entire folder to your Web server.
3. Perform the following steps to specify the path for the Help files:

a. Click the Commands button in the HTTP interface.
b. Select the Help tab located at the top of the screen.
c. Enter the pathname where the Help files are located in the Help Link box. This must be an HTTP address.
d. Click OK.

1. Make sure you have the proper IP Address. Enter your AP IP address in the Telnet connection dialog, from a DOS 

prompt, type:
         C:\> telnet <AP IP Address>

2. Use the CLI over the serial port to check the IP Access Table, which can be restricting access to Telnet and HTTP.

1. Make sure the TFTP Server has been started.
2. Verify the IP address of the TFTP Server. The server may be local or remote, so long as it has a valid IP address.
3. Configure the TFTP Server to “point” to the folder containing the file to be downloaded (or to the folder in which the file 

is to be uploaded).

4. Verify that you have entered the proper AP Image file name (including the file extension) and directory path (if 

needed).

5. If you have a problem uploading a file, verify that the TFTP server is configured to allow uploads (typically the default 

setting is to allow only downloads).

Make sure you have configured your client software with the proper Network Name and Security settings. Network 
Names and WEP Keys are typically allocated and maintained by your network administrator.