Proxim AP-4000 Benutzerhandbuch

Configuring the AP using CLI commands

The string delimiter does not have to be used for every string object. The single quote or double quote only has to be 
used for string objects that contain blank space characters. If the string object being used does not contain blank spaces, 
then the string delimiters, single or double quotes, mentioned in this section are not required.

1. Open your terminal emulation program (like HyperTerminal) and set the following connection properties:

•

Com Port: <COM1, COM2, etc., depending on your computer>

•

Baud rate: 9600

•

Data Bits: 8

•

Stop bits: 1

•

Flow Control: None

•

Parity: None

2. Under File > Properties > Settings > ASCII Setup, enable the Send line ends with line feeds option. 

HyperTerminal sends a line return at the end of each line of code.

3. Enter the CLI password (default is public).

The CLI commands can be used to access, configure, and manage the AP using Telnet. Follow these steps:

1. Confirm that your computer’s IP address is in the same IP subnet as the AP.

2. Go to the DOS command prompt on your computer.
3. Type telnet <IP Address of the unit>.
4. Enter the CLI password (default is public).

There are a few basic configuration parameters that you may want to setup right away when you receive the AP. For 
example:

•

•

•

•

•

•

•

•