Proxim AP-4000 Benutzerhandbuch

Command Line Interface (CLI)

AP-4000 Series User Guide

Other Network Settings

180

[Device-Name]>set serbaudrate <2400, 4800, 9600, 19200, 38400, 57600>
[Device-Name]>set serflowctrl <none, xonxoff>
[Device-Name]>show serial

Figure A-16 Result of “show serial” CLI Command

Configure Syslog

[Device-Name]>set syslogpriority <1–7 (default is 6)>
[Device-Name]>set syslogstatus <enable/disable>
[Device-Name]>set sysloghbstatus <enable/disable> (default is disable)
[Device-Name]>set sysloghbinterval <1–604800> (default is 900 seconds)
[Device-Name]>set sysloghosttbl <index> ipaddr <ipaddress> cmt <comment> status
<enable/disable>

Configure Intra BSS

[Device-Name]>set intrabssoptype <passthru (default)/block)>

Configure Wireless Distribution System

Create/Enable WDS

[Device-Name]>set wdstbl <Index> partnermacaddr <MAC Address> status enable

Enable/Disable WDS

[Device-Name]>set wdstbl <Index> status <enable/disable>

NOTE: <Index> is 3.1–3.6 (Wireless A) or 4.1–4.6 (Wireless B). To determine the index, type show wdstbl at the

prompt.

Configure MAC Access Control

Setup MAC (Address) Access Control

[Device-Name]>set wifssidtbl <index> aclstatus enable/disable
[Device-Name]>set macacloptype <passthru, block>
[Device-Name]>reboot 0

Add an Entry to the MAC Access Control Table

[Device-Name]>set macacltbl 0 macaddr <MAC Address> status enable
[Device-Name]>show macacltbl

Disable or Delete an Entry in the MAC Access Control Table

[Device-Name]>set macacltbl <index> status <disable/delete>
[Device-Name]>show macacltbl

NOTE: For larger networks that include multiple Access Points, you may prefer to maintain this list on a centralized

location using the RADIUS parameters (see

Set RADIUS Parameters