Proxim AP-4000 Benutzerhandbuch

AP-4000 Series Hardware Description

The AP-4000/4000M/4900M includes a a power jack, a 10/100 base-T Ethernet port, and an RS-232 serial data 
communication port. The AP includes an optional security cover that can be installed to protect against access to the 
power and LAN cables and to the reset and reload buttons. See 

The AP-4000/4000M/4900M has been designed to rest horizontally on a flat surface, but can be wall- or ceiling- mounted 
with the long axis vertical. The unit includes screw slots in the bottom plastic for mounting to a flat wall or ceiling.

Each radio on the AP-4000/4000M/4900M employs two internal antennas for antenna diversity: one is vertically 
polarized, and the other is horizontally polarized to provide optimal spatial and polarization diversity. When the AP is hung 
on the wall of an office or building, the horizontally polarized antenna provides coverage for that particular floor level. The 
vertically polarized antenna provides spatial diversity for the horizontally polarized antenna in the event of an antenna 
null. In addition, the vertically polarized antenna provides some coverage above and below the current floor level. When 
the AP is mounted on the ceiling or sitting on a table, the effect is the same, but the roles of the two antennas switch. 

The AP supports both receive and transmit diversity. When receiving, the AP chooses the antenna that recieves the 
strongest signal. When transmitting, the AP chooses the antenna with the highest success rate, and broadcasts are 
transmitted on alternating antennas. 

Antenna diversity is enabled by default (set to “auto”) per wireless interface. When using the internal antennas, Proxim 
recommends leaving antenna diversity enabled. However, you may disable antenna diversity by manually selecting 
which antenna to use for each wireless interface through the Command Line Interface. See 

for information.

When operating in 4.9 GHz Public Safety mode, an external 4.9 GHz antenna must be attached to the pigtail connected 
to Antenna connector 3 (and the corresponding internal antenna is disabled). See 

 for information and 

 for installation instructions. 

The AP-4000/4000M/4900M also has four antenna connectors, two on each radio, for use with external antennas. 
External antennas can be used with either radio on the AP-4000/4000M/4900M.