PROLINK Huricane 9200/S Benutzerhandbuch

Chapter

. Upgrading the Software and Storing and Restoring the Configuration Data

179

4. Select the file, and then click

The following message box displays at the bottom of the page:

When loading is complete, the following message displays (the

file name may differ):

5. Turn off power to the unit, wait a few seconds, and turn it on

again.

The new software will now be in effect. If the system fails to boot or

is not working properly, contact your ISP for assistance.

Follow this procedure if the upgrade file is available by downloading

from your ISP. Contact your ISP to obtain the server and logon

information required.
1. Log into Configuration Manager, click the Admin tab, and

then click

! ('!

in the task bar.

The Remote Image Upgrade page displays.

Figure 84. Remote Image Upgrade Page

Note

If the page does not display a table as shown in Figure 84, but

displays only the Upload button, skip to step 5. In this case, the

download server IP address, filename, and logon information has

already been hard-coded into your system.

2. In the IP Address text boxes, type the IP address of the

server from which the file is to be downloaded.

3. In the Upgrade File text box, type the complete name of the

file to be downloaded and installed.
The file name can be either TEImage*.bin or TEPatch*.bin,

where * represents any number of characters.

4. In the Username and Password fields, type the logon

information to the ISP's server (if the ISP requires it).