PowerTec OMRG25204 Benutzerhandbuch
Lubrication and Maintenance
OURGP11,0000007
–19–31OCT06–1/2
Lubrication and Maintenance Service Interval
Chart—Generator (Standby) Applications
Chart—Generator (Standby) Applications
NOTE: Use service intervals listed below for generator
(standby) applications. Match service items below
to titles in Lubrication and Maintenance Sections
for procedures.
to titles in Lubrication and Maintenance Sections
for procedures.
Lubrication and Maintenance Service Intervals
Every 2
250 Hours or
500 Hours or
2000 Hours
Item
Weeks
12 Months
12 Months
or 24 Months
As Required
Operate Engine at Rated Speed and 50%–70% Load a
•
Minimum of 30 Minutes
Check Engine Oil and Coolant Level
•
Check Fuel Filter(s)/Water Separator Bowl
•
Check Air Cleaner Dust Unloader Valve & Indicator
a
•
Perform Visual Walkaround Inspection
•
Service Fire Extinguisher
•
Change Engine Oil and Replace Oil Filter
b
•
Check Engine Mounts
•
Service Battery
•
Clean Crankcase Vent Tube
•
Check Air Intake Hoses, Connections, & System
•
Replace Single or Dual Fuel Filter Elements
•
Check Belt Tensioner and Belt Wear
•
Check Engine Speeds
•
Check Engine Electrical Ground Connection
•
Check Cooling System
•
Coolant Solution Analysis-Add SCAs as required
•
Pressure Test Cooling System
•
Check Variable Speed (Droop) (Gen-Sets)
•
Check Crankshaft Vibration Damper
(6.8 L Engines)
c
•
Flush Cooling System
d
•
Test Thermostats
•
Check and Adjust Engine Valve Clearance
•
Add Coolant
•
Replace Air Cleaner Elements
•
a
Replace primary air cleaner element when restriction indicator shows a vacuum of 625 mm (25 in.) H2O.
b
Change the oil for the first time after 100 hours maximum of break-in operation. For subsequent oil and filter intervals, see recommendations
in section 10.
c
Replace crankshaft damper every 4500 hours or 60 months, whichever occurs first.
d
If John Deere COOL-GARD is used, the flushing interval may be extended to 3000 hours or 36 months. If John Deere COOL-GARD is used
and the coolant is tested annually AND additives are replenished as needed by adding a supplemental coolant additive, the flushing interval
may be extended to 5000 hours or 60 months, whichever occurs first.
may be extended to 5000 hours or 60 months, whichever occurs first.
20-4
110306
PN=66
Continued on next page