Polar Exercise Bike CS200 Benutzerhandbuch
14
– ENGLISH
5. Attach the magnet to a
spoke at the same level as
the sensor. The magnet hole
must be facing the speed
sensor. Fasten the magnet to
the spoke and tighten it
loosely with a screwdriver.
Do not tighten it fully yet.
spoke at the same level as
the sensor. The magnet hole
must be facing the speed
sensor. Fasten the magnet to
the spoke and tighten it
loosely with a screwdriver.
Do not tighten it fully yet.
Fine-tune the positioning of both the magnet and the speed
sensor so that the magnet passes close to the sensor but
does not touch it. Adjust the sensor towards the wheel/
spokes as much as possible. The gap between the sensor
and the magnet should be under 4 mm/0’16’’. The gap is
correct when you can fi t a cable tie just about between the
magnet and the sensor.
sensor so that the magnet passes close to the sensor but
does not touch it. Adjust the sensor towards the wheel/
spokes as much as possible. The gap between the sensor
and the magnet should be under 4 mm/0’16’’. The gap is
correct when you can fi t a cable tie just about between the
magnet and the sensor.
Rotate the front tyre so that you can see a speed reading on
the display of your cycling computer. The reading indicates
that the magnet and the speed sensor are positioned
correctly. Once the magnet and the speed sensor are
positioned correctly, tighten the screw to the magnet with a
screwdriver. Also tighten the cable ties securely and cut off
any excess cable tie ends.
the display of your cycling computer. The reading indicates
that the magnet and the speed sensor are positioned
correctly. Once the magnet and the speed sensor are
positioned correctly, tighten the screw to the magnet with a
screwdriver. Also tighten the cable ties securely and cut off
any excess cable tie ends.
Your safety is important to us. While riding your bike,
please keep your eyes on the road to prevent any accidents
and injury. Check that you can turn the handlebar normally
and that the cable wires for brakes or gearing do not catch
on the bike mount or the sensors. Check also that the bike
mount or sensors does not hamper pedaling or the use of
brakes or gearing.
please keep your eyes on the road to prevent any accidents
and injury. Check that you can turn the handlebar normally
and that the cable wires for brakes or gearing do not catch
on the bike mount or the sensors. Check also that the bike
mount or sensors does not hamper pedaling or the use of
brakes or gearing.
Before you start cycling, you should set the wheel size of your
bicycle into the cycling computer. For further information
see pages 45-48.
bicycle into the cycling computer. For further information
see pages 45-48.
5.
max
4 mm /
0’16”
4 mm /
0’16”