Troy-Bilt 78 Benutzerhandbuch

To remove/replace the dip stick tube:

NOTE: The procedure to remove the dip stick tube is the 

same for both styles of dip stick.

NOTE: A threaded dip stick and tube assembly is inter-

changeable with a quarter turn dip stick and tube 
assembly.

1.     Remove the upper screw that secures the dip stick 

tube to the fuel tank support bracket using a 10 mm 
wrench. See Figure 5.4.

2.

Remove the screw at the bottom of the dip stick tube 
using a 10 mm wrench. See Figure 5.4.

3.

Pull the dip stick tube out of the engine block.

4.

Inspect the O-rings on the dip stick and the dip stick 
tube. Replace if damaged.

NOTE: Lubricate the O-ringfor installation.

5.

Install by following the above steps in reverse order.

Remove these

screws

For Parts Call 606-678-9623 or 606-561-4983

www.mymowerparts.com