Troy-Bilt 78 Benutzerhandbuch

 If damage is suspected, the recoil may be disassembled 
by:

NOTE: The recoil spring is nested within the starter pulley 

and both parts are sold as a single part number.

1.         Remove the starter by following the steps 

described earlier in this chapter.

2.

Relieve the spring tension by:

2a.

Pull some slack in the rope inside of the starter

2b.

Hook the rope into the notch in the starter pul-
ley.

2c.

Wind the pulley clockwise until all tension is 
removed.

3.

Remove the shoulder screw and pressure plate using 
a 10 mm wrench. See Figure 6.7.

NOTE: Beneath the pressure plate is a compression 

spring and two starter pawls that are held in the 
disengaged position by two torsion springs.

4.

Inspect the pawls and torsion springs for wear and 
damage. See Figure 6.8.

Pressure plate

Eye protection should be worn if 
the starter pulley is to be removed.

Torsion springs

Pawls

For Parts Call 606-678-9623 or 606-561-4983

www.mymowerparts.com