Tribest FS-610 Benutzerhandbuch







›




Turn the lid towards ⶸclose mark.

Place the juice cup properly. 

Assemble the entire top set onto the base. As shown above, assemble the bowl onto the 
base and twist the bowl so that the lid edge in pointing to ⶼ‘close’ sign.

Assemble the entire juicing unit [Vertical Auger + Juicing Screen + Pulp Wiping Assembly + 
Auger housing +Feeding Chute Assembly] to the Main Body. Locate the small white arrow on 
the rear side of the Auger Housing Lid and set it to meet the arrow at “Open” position on the 
rear top of the Main Body.

Turn the Auger Housing clock-wise until the arrow on the Auger Housing Lid aligns to the ar-
row at “Close”     position of the Main Body. Make sure the aligning mark at “Close” position on 
the Auger Housing lid and the red dot on the Auger Housing are exactly aligned.

Properly place the Juice Container 
and Pulp Container at the base of the 
juice/pulp spouts.





Screw

Strainer

Rotation Wiper

Drum Lid

Drum

Assembly position 
mark

Juicing bowl 
assemble mark

Strainer assemble 
mark

Juicing bowl 
assemble mark

Place the screw into a center of strainer. 

*  Spin and push the juicing screw while inserting into 

the strainer.

Screw + Strainer + Rotation wiper
Make sure 

the red dots

      are aligned.

By turning it the clock-wise, make sure   
the spot

       

on the lid and 

the red spot

 

      on the bowl is aligned.

Connect the lid and the bowl through                         

the red spot               

assembles mark and 

assemble it.

Place the Vertical Auger into the center of 
the Juicing Screen. Then place the Juicing 
Screen into the Pulp Wiping Assembly. 
Turn and push down the Juicing Screen 
while inserting it into the Pulp Wiping 
Assembly.

Insert (Vertical Auger + Juicing Screen 
+ Pulp Wiping Assembly) into the Auger 
Housing.

Make sure the red dot on the Juicing 
Screen and the red dot on the Auger 
Housing are aligned.

Vertical Auger

Juicing Screen

Pulp Wiping 
Assembly

Red Dot on 
Juicing Screen

Red Dot on 
Auger Housing

Connect the Feeding Chute Assembly to 
the Auger Housing. Align the mark of the 
“OPEN” position on the Auger Housing Lid 
to the red dot on the Auger housing. 

Turn the Feeding Chute Assembly clockwise 
until the mark of the “CLOSE” position aligns 
to the red dot on the Auger Housing. 

Align mark at 
“OPEN” position 
on the Auger 
Housing Lid

Red Dot on 
Auger Housing

Auger 
Housing Lid

Auger 
Housing