Panasonic Arbitrator 360 Installationsanleitung
2) Appendix: Manual Migration from P2 card for the wireless upload users
a) Introduction
If you usually use wireless upload to transfer the video from P2 card in VPU to Server but sometimes need manually
taking P2 card out from VPU and ingest the video from P2 card to Server, it is necessary to follow the instruction below.
1. If you have enabled the network connection between the Server and the wireless router / access point via LAN cable,
GO TO the below c).
2. If you have disabled the network connection between the Server and the wireless router / access point via LAN
cable,
GO TO the below b) and then c) to install “Microsoft Loopback adaptor”.
taking P2 card out from VPU and ingest the video from P2 card to Server, it is necessary to follow the instruction below.
1. If you have enabled the network connection between the Server and the wireless router / access point via LAN cable,
GO TO the below c).
2. If you have disabled the network connection between the Server and the wireless router / access point via LAN
cable,
GO TO the below b) and then c) to install “Microsoft Loopback adaptor”.
b) Get virtual IP address by “Microsoft Loopback adapter”
To manually install the Microsoft Loopback adapter in Windows XP, follow these steps:
1. Click Start, and then click Control Panel.
2. If you are in Classic view, click Switch to Category View under Control Panel in the left pane.
3. Double-click Printers and Other Hardware, and then click Next.
4. Under See Also in the left pane, click Add Hardware,and then click Next.
5. Click Yes, I have already connected the hardware, and then click Next.
6. At the bottom of the list, click Add a new hardware device, and then click Next.
7. Click Install the hardware that I manually select from a list, and then click Next.
8. Click Network adapters, and then click Next.
9. In the Manufacturer box, click Microsoft.
10. In the Network Adapter box, click Microsoft Loopback Adapter, and then click Next.
11. Click Finish.
1. Click Start, and then click Control Panel.
2. If you are in Classic view, click Switch to Category View under Control Panel in the left pane.
3. Double-click Printers and Other Hardware, and then click Next.
4. Under See Also in the left pane, click Add Hardware,and then click Next.
5. Click Yes, I have already connected the hardware, and then click Next.
6. At the bottom of the list, click Add a new hardware device, and then click Next.
7. Click Install the hardware that I manually select from a list, and then click Next.
8. Click Network adapters, and then click Next.
9. In the Manufacturer box, click Microsoft.
10. In the Network Adapter box, click Microsoft Loopback Adapter, and then click Next.
11. Click Finish.
After the adapter is installed successfully, you can manually configure its options, as with any other adapter. If the TCP/IP properties are
configured to use DHCP, the adapter will eventually use an autonet address (169.254.x.x/16) because the adapter is not actually connected to
any physical media.
Note By default, TCP/IP properties are configured to use DHCP.
configured to use DHCP, the adapter will eventually use an autonet address (169.254.x.x/16) because the adapter is not actually connected to
any physical media.
Note By default, TCP/IP properties are configured to use DHCP.
Make sure that “Loopback Adaptor” is enabled.
<Auto Upload>
Go to “Configuration” at Insight
Watchdog and set up the IP range for
the access points/ in car PC.
Make sure to input the Server IP
address and set up
address and set up
“True”
on “Use
Auto Upload” at SI Config menu.
Without
Without
going to
“Upload”
and
pressing “Upload” at SI Upload menu,
it will be uploaded automatically.
it will be uploaded automatically.