Toro Twilight Golf Cup Designanleitung

  WARNING: Risk of electric shock. Turn 

1.  Remove sod and excavate a 12” deep (below 

aeration depth) trench for the UF supply line 

cable or conduit and lightpost. The lightpost 

requires a 10” diameter hole to facilitate 

installation to a depth of 18”.

2.  Feed the incoming UF supply line cable or 

conduit through the slanted bottom of the 

lightpost (Figure 5-1). Provide 30” of wire 

from the bottom to allow for future servicing. 

If wiring multiple light fixtures in a series, make 

sure you pull the second (continuing) supply 

wire through the lightpost.

3.  Connect the supply wires to the ToroCap’s wires 

using the included wire nuts (Figure 5-2).

4.  Encase all wire connections in the supplied 

water-proof grease caps (Figure 5-3).

5.  Push all wires back into the Landscape 

LightPost and slide ToroCap back on.

6.  Align holes on ToroCap with holes on the 

Lightpost. Start all three included screws, then 

tighten. (Figure 6).  

7.  Place the now wired LightPost into the 

excavated trench and position to the desired 

height. If wiring multiple fixtures, adjust the 

incoming and outgoing supply wires or conduit 

at the bottom of the LightPost so the wires or 

conduit do not bind.

8.  Open the cover-flap on the ToroCap. The 

Twilight Golf Post Light is keyed with an 

alignment screw. Align with the slot on the base 

and insert the light (Figure 7).
(See Figures 8 and 9 for lamp head 

adjustments.)

From transformer

To next light post

Insert wires into
wire nuts and twist.

Feed wires
through lightpost.

Insert wire nuts
into grease caps
and latch.

Lightpost: TWGP-STAKE

Cable: TWGP-12-2-500

ToroCap: TWGP-ELECREC

30˝