Telos ZephyrExpress Benutzerhandbuch

If ZephyrExpress’ LEDs light when you first apply power but the LCD screen
appears dark, or the LCD screen lights but no characters appear, the last user
may have left its brightness or contrast at an extreme setting. To reset:

p

d

•

Press the DROP button and hold that button in while turning the Edit

knob clockwise to reset the backlighting. It may take a few turns.

•

Press the DIAL button and hold that button in while turning the Edit

knob either direction to change the LCD Contrast.

Telos Systems maintains ISDN test lines with continuously-playing music. Feel
free to dial into them from your ZephyrExpress to test your setup or line.

·  USA: +216 781.9310, +216 781.9311 (Layer 3 Dual transmit @ 32 kHz sample

rate. Dial just one number to test Layer 3 Mono, or dial both numbers to test
Layer 3 Dual. You can also test Layer 3 Stereo by dialing both numbers; a
slight distortion of the stereo image may result because you’re receiving our
Dual test signal rather than true stereo. Your ZephyrExpress will work
correctly with a stereo transmission.)

·  Germany: (49) 81 61 42 061 (Layer 3 Dual transmit @ 32 kHz sample rate; dial

once to test Layer 3 Mono, or dial twice to test Layer 3 Dual. The warning
about Layer 3 Stereo, above, applies.)

·  Germany: (49) 81 61 42 062 (Layer 2 Mono @ 48 kHz; ZephyrExpress must be

set to Layer 2 receive. Only one line is required.)

h

ZephyrExpress will dial a test line for you:

1) Verify 

that 

the 

word 

Ready 

appears twice on the LCD screen. If it doesn’t, you

have an ISDN  problem  and  can’t place a call. ISDN setup instructions appear in
this booklet.

2) Press 

the 

DIAL button

3) Turn 

the EDIT knob to select 

Auto... 

and tap the EDIT knob in toward the

panel to confirm that choice

4) Turn 

the 

EDIT 

knob to select a test line and tap  the  knob again

5) The 

word

 Go! 

will be highlig hted on the  screen.  Tap  the  knob one more time,

and ZephyrExpress  will place  the call.