Tektronix Ventilation Hood AWG710 Benutzerhandbuch

Appendix B: Performance Verification (AWG710B)

B-50

AWG710&AWG710B Arbitrary Waveform Generator User Manual

Marker Output Tests

These procedures check the accuracy of the AWG710B Arbitrary Waveform
Generator marker output level.

Do the following steps to install the test hookup and set the test equipment controls:

1. Use a 50

BNC coaxial cable, a SMA(Ma)–BNC(Fe) adapter, a 50

precision terminator, and a BNC–to–dual banana adapter to connect the
AWG710B Arbitrary Waveform Generator MARKER 1 OUT to the DMM
input connector (see Figure B-33).

Figure B-33: Marker output initial test hookup

2. Set the DMM controls as follows:

3. Follow the substeps below to set the AWG710B Arbitrary Waveform

Generator controls and to select the sequence file:

NOTE.

Connect a 50

SMA terminator to the inverted marker output connector

during the marker output tests.

Equipment
required

A 50

BNC coaxial cable, a 50

precision terminator, a

SMA(Ma)–BNC(Fe) adapters, BNC (female)–to–dual banana adapter,
and a digital multimeter (DMM).

Prerequisites

The AWG710B Arbitrary Waveform Generator must meet the
prerequisites listed on page B-7.

Mode . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . VDC

Range . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Auto

Input . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Front

AWG710B Arbitrary Waveform Generator

DMM

BNC coaxial

cable

MARKER 1 out connector
+ SMA(Male)-BNC(Female) adapter
+ BNC 50

precision terminator

+ 50

BNC coaxial cable

Input connector
+ BNC-to-dual banana adapter
+ 50

BNC coaxial cable