Teka EX/60 4G AI FUND Benutzerhandbuch

11

Replacement of the components housed inside
the appliance: remove the trivets and the burners
from the upper part of the working table; remove
the fixing screws "V" of the burner (fig. 14) and the
knobs fixed by pressure with the hans, in order to
take off the appliance.
After having carried out the above listed
operations, the burners (fig.15), taps (fig. 16) and
electrical components can all be replaced (fig. 17).
It is advisable to change seal "D" whenever a tap
is replaced to ensure a perfect tightness.

Greasing the taps (see fig. 18 - 19)
If a tap becomes stiff to operate, it must be
immediately greased in compliance with the
following instructions:
-  Remove the tap.
-  Clean the cone and its housing using a cloth

soaked in diluent.

-  Lightly spread the cone with the relative grease.
-  Fit the cone back in place, operate it several

times and then remove it again. Eliminate any
excess grease and check that the gas ducts have
not become clogged.

-  Fit all parts back in place, complying with the

demounting order in reverse.

-  Ceck the tightness by using soapy water. The use

of the flame is prohibited.

To facilitate the servicing technician's task, here is a
chart with the types and sections of the powering
cables and the ratings of the electrical components.