Tech Lighting 700KESUN Merkblatt
2
Installing the Sun Fixture
FOR HORIZONTAL
KABLE LITE CABLES
KABLE LITE CABLES
Sun can be connected to horizontal or vertical Kable Lite
cables by rotating the arms 90°.
cables by rotating the arms 90°.
NOTE:
The Kable Lite cable separation must be
between 7.5" to 8".
FOR VERTICAL
KABLE LITE CABLES
KABLE LITE CABLES
Loosen the thumb screws.
Place one arm slot on each Kable Lite cable and tighten
the thumb screws.
the thumb screws.
ARM
ARM
THUMB
SCREW
SCREW
KABLE LITE CABLES
IMPORTANT SAFETY INSTRUCTIONS
To reduce the risk of fire, electrical shock, exposure to
excessive UV radiation, or injury to person:
excessive UV radiation, or injury to person:
– Use this fixture indoors only.
– Do not look directly at the lighted lamp.
– Do not remain in light if skin feels warm.
– Risk of fire: Use only the type of lamp and maximum
wattage indicated in this instruction manual.
wattage indicated in this instruction manual.
– Never cover the halogen lamp with anything other than a
Tech Lighting lamp shield and never place flammable
material close to your fixture.
Tech Lighting lamp shield and never place flammable
material close to your fixture.
– Never turn the fixture on and off by connecting and
disconnecting the halogen lamp.
disconnecting the halogen lamp.
– Do not touch the fixture shades or lamp shield while the
fixture is on. These surfaces may be HOT.
fixture is on. These surfaces may be HOT.
Halogen Lamp General Information
– A new halogen lamp may smoke slightly when it is used for
the first time. This is perfectly normal; the protective
coating is simply being vaporized.
the first time. This is perfectly normal; the protective
coating is simply being vaporized.
Two Tips For Prolonging Halogen
Lamp Life
Lamp Life
– First avoid touching the lamp with bare hands during
installation. Any contaminant, even the oil from your
hands can deteriorate the lamp. Rubbing alcohol can be
used to remove any contaminant.
installation. Any contaminant, even the oil from your
hands can deteriorate the lamp. Rubbing alcohol can be
used to remove any contaminant.
– Second, do not run the lamps at full power when you do
not need to. However, if dimming the fixture for an
extended period of time, occasionally bring the light up to
full brightness for a few minutes to complete the halogen
cycle.
not need to. However, if dimming the fixture for an
extended period of time, occasionally bring the light up to
full brightness for a few minutes to complete the halogen
cycle.
SAVE THESE INSTRUCTIONS!
2A
2B
1
1
1
2
3
2
3
7400 Linder Ave, Skokie, IL 60077
847.410.4400
www.techlighting.com
© 2008 Tech Lighting, L.L.C. All rights reserved. The "Tech Lighting" graphic is
a registered trademark of Tech Lighting, L.L.C. Tech Lighting reserves the right
to change specifications for product improvements without notification.
a registered trademark of Tech Lighting, L.L.C. Tech Lighting reserves the right
to change specifications for product improvements without notification.
A Generation Brands Company