Oceanic Dive Computer Pro Plus 2 Benutzerhandbuch

•  If moisture is found, it is best to have the unit inspected

and cleaned by an Authorized Oceanic Dealer.

•  If it is necessary to clean the Battery Compartment, flush

the it and all components with a solution of 50% white
vinegar and 50% fresh water.  Rinse with fresh water,
and allow to dry overnight, or blow dry with a hair dryer
(set at 'no heat').

•  Closely check all of the sealing surfaces for any signs of

damage that might impair proper sealing.

•  Inspect the Buttons, Lens, and Housing to ensure they are

not cracked or damaged.

•  Replace the Hatch O-ring with a new one.  This O-ring

must be a genuine Oceanic part that can be purchased
from an Authorized Oceanic Dealer.   Use of any other
O-ring will void the warranty.

•  Lightly lubricate the new Hatch O-ring with silicone

grease and place it on the beveled outer edge of the
Battery Compartment (Fig. 97a).  Ensure that it is evenly
seated.

•  Place a new 3 volt, CR2, .75 AHr, Lithium Battery

(Duracell model DL-CR2 or equivalent) negative end first
into the Battery Compartment with the negative end
toward the spring (Fig. 98a).

Fig. 97  - O-ring Installation

a

Fig. 98  - Battery Orientation

a