Q-Logic Computer Drive IB0056101-00 G Benutzerhandbuch

4 – Hardware Installation
Hardware Installation Requirements

4-2

IB0056101-00  G

S

Installation of the QLE7240, QLE7280, QLE7140, QHT7040, or QHT7140 in a 1U 
or 2U chassis requires the use of a riser card. See 

 for an illustration of 

a PCI Express (PCIe) slot in a typical motherboard. See 

 for an 

illustration of an HTX slot for a typical Opteron motherboard. 

The motherboard vendor is the optimal source for information on the layout and 
use of HyperTransport and PCI Express-enabled expansion slots on supported 
motherboards. 

The QLE7240, QLE7280, and QLE7140 are the model numbers for the adapters 
that ship in the standard PCI Express half-height, short-form factor. These 
adapters can be used with either full-height or low-profile face plates.

The QHT7040 is the model number for the adapter that shipped in the HTX 
full-height factor. The HTX low-profile form factor is referred to as the QHT7140. It 
is the same as the QHT7040, except for its more compact size. In either case, the 
adapter is backward and forward compatible for the motherboards in which it is 
supported. The QHT7040 and QHT7140 HTX adapters are collectively referred to 
as the QHT7140 unless otherwise stated.

When the QHT7040 or QHT7140 adapter is installed with the riser card, it may 
prevent some or all of the other PCI expansion slots from being used, depending 
on the form factor of the adapter and motherboard.

Run i

path_control -i

 to see information on which form adapter is installed. 

The file 

/sys/bus/pci/drivers/ib_ipath/00/boardversion

 contains the 

same information. For more information, see the Troubleshooting appendix in the 
QLogic HCA and InfiniPath Software User Guide.

QLE7140

PCI Express systems

Standard PCI Express x8 or x16 slot

QHT7040

Motherboards with HTX connectors HyperTransport HTX slot

QHT7140

Motherboards with HTX connectors HyperTransport HTX slot