Nortel Networks Circuit Card Benutzerhandbuch
NT5D97 Dual-port DTI2/PRI2 card
Page 347 of 906
NT5D97AD DIP switch settings
The the NT5D97 DDP2 card is equipped with 6x2 sets of DIP switches for
trunk parameters settings for port0 and port1 respectively. Additionally, the
DDP2 card is equipped with one set of four DIP switches for the Ring Ground
setting. The NT5D97AA/AB has one set of eight DIP switches and
NT5D97AD has two sets of ten DIP switches for the D-channel Handler
parameters setting.
trunk parameters settings for port0 and port1 respectively. Additionally, the
DDP2 card is equipped with one set of four DIP switches for the Ring Ground
setting. The NT5D97AA/AB has one set of eight DIP switches and
NT5D97AD has two sets of ten DIP switches for the D-channel Handler
parameters setting.
The DIP switches are used for the setting of default values of certain
parameters. Firmware reads the general purpose switches, which sets the
default values accordingly.
parameters. Firmware reads the general purpose switches, which sets the
default values accordingly.
Refer to DIP switch locations in Figure 76 on
The following parameters are set by DIP switches. The boldface font shows
the factory set-up.
the factory set-up.
Table 129
DIP switch settings for NT5D97AD
DIP switch settings for NT5D97AD
Card
Trunks
0 and 1
0 and 1
Port 0
Port 1
Trunk 0
Trunk 1
ENB/DSB
mounted on the face plate
mounted on the face plate
S1
Ring Ground
S16
DPNSS
S8
S9
MSDL
S9
TX Mode
S2
S10
LBO Setting
S3
S13
S4
S14
S5
S15
Receiver Interface
S6
S11
General Purpose
S12
S7