NewAir APH-4000PV Benutzerhandbuch

instructions, and of the hazards involved. If this heater is used in a commercial or
rental installation, it is the responsibility of the purchaser to check with the local
codes for properly acquainting with the safety precautions and instructions.

Failure  to  comply  with  the  precautions  and  instructions  provided  with  this
heater  can  result  in  death,  serious  bodily  injury  and  property  loss  or
damage  from  hazards  of  fire,  explosion,  burn,  asphyxiation,  carbon
monoxide  poisoning.  Be  sure  you  understand  all  operation  instructions
before attempting to operate or service this heater.

1. Assembly

Note: The assembly of this heater requires basic mechanical skills.  Proper
           assembly is the responsibility of the installer.  All service and repair should
           be done by a qualified person.

1.1

Tools required

     8mm, 10mm, 11mm, 12mm Socket
     #2 & #3 Phillips Head Screwdriver
     Pliers or Channel Lock Pliers
     Crescent or Open End Wrenches
Caution:
Do not use Teflon Tape or any thread sealing compounds where connections
between heater head to Fuel-Tube and Regulator / Hose assembly  to Fuel-
Tube.

1.2 Unpacking

Remove the Fuel-tube, the Post and Heater burner assembly from the

Box 2 of 2.

Take out the heater burner assembly from the base assembly by removing the

three Hex-Nuts, Flat washers and Lock washers, then screw the nuts and
washers back onto the bolts at the top of the burner assembly.

Remove all shipping packaging foam on the components.
Check the fasteners, Regulator assembly and the Owner’s Manual provided

by the factory.

Remove the Reflector from the Box 1 of 2.
Check the heater for any shipping damage, if any is found, immediately

contact and return this heater to the dealer or distributor where purchased.

Retain all packaging material and carton until heater warranty has expired.

Any warranty returns require original packing and carton.

1.3 Component List

(see Figure 1)