NewAir Kegerator AK-200 Benutzerhandbuch

Illustration A
Black Rubber Washer Installed in Wing Nut

Illustration B
Then Attach to CO2 Bottle Connector

fig.1

fig.2

fig.3

fig.4

fig.5

Connect to the
Beer Line Tube

Black pull handle

Keg Coupler

Connect to
CO2 Gas
Line Tube

OCKWISECL

RN

TU

Beer Keg Neck

Lift Upright

Beer Keg

Keg Support

Make sure that the kegerator is plugged in properly to a 120V, 60Hz, 
15Amps grounded AC power outlet.

Place the drip tray under the beer faucet to avoid messes from excess beer.

Open  the  beer  faucet  by  pulling  the  tap  towards  you  to  dispense  the  beer.         
Note: If for any reason the beer does not come out of the tap, please refer to the 
“Tapping the Beer Keg - Installing Keg Tap” section.

Increase the pressure if the beer runs too slowly.

Hold  the  glass  steady  at  a  45°  angle.  When  it  is  2/3  full,  straighten  the  glass. 
Proper foam should be a tight creamy head and the collar on an average glass 
should be ¾” to 1” high, ideally.

1.

2.

3.

4.

5.

9