National Instruments NI-488.2 Benutzerhandbuch

© National Instruments Corporation

7.

Click on the OK button to save your changes.

On the Device Manager tab, the disabled device has a red X overlaid 
on it. The red X indicates that the device is disabled.

To remove your GPIB interface from the Device Manager, complete the 
following steps:

1.

On the Device Manager tab, double-click on the National 
Instruments GPIB Interfaces item. If you are removing a 
PCMCIA-GPIB+ interface, double-click on the Multifunction 
Adapters item.

2.

Click on the GPIB interface that does not have an interrupt resource 
and click on the Remove button. If you are removing a 
PCMCIA-GPIB+ interface, click on the NI PCMCIA-GPIB+ 
Multifunction Parent item and click on the Remove button.

On the Device Manager tab, click on the Refresh button.

If your GPIB interface does not appear under National Instruments GPIB 
Interfaces, your GPIB interface is not Plug and Play. In this case, you must 
use the Add GPIB Hardware Wizard to reinstall your interface. To start the 
wizard, select Start»Programs»National Instruments NI-488.2»Add 
GPIB Hardware and follow the instructions on the screen.

To get started with your GPIB hardware and the NI-488.2 software, use the 
NI-488.2 Getting Started Wizard. To do so, select Start»Programs»
National Instruments NI-488.2»Getting Started Wizard.

Run the NI-488.2 Troubleshooting Wizard. To do so, select 
Start»Programs»National Instruments NI-488.2»Explore GPIB. Then, 
select Help»Troubleshooting»NI-488.2 Troubleshooting Wizard.