Namco Bandai Games Utility Trailer 90500013 Benutzerhandbuch
Page 40
5-3 Fitting the Ride Base Assembly
1.
Remove 4off Hex head screws (M8x30), flat and spring washers, and
remove the joint brackets from the base ride.
remove the joint brackets from the base ride.
2.
Place the Ride Base Assembly close to the monitor cabinet.
3.
Connect the connectors and air tube between the Ride Base and the
monitor cabinet and push the Ride Base up to the monitor cabinet, taking
care not to trap the cable or connectors.
monitor cabinet and push the Ride Base up to the monitor cabinet, taking
care not to trap the cable or connectors.
4.
Fit the joint brackets to the Ride Base and Monitor Cabinet using the 4off
Hex head screws (M8x30).
Hex head screws (M8x30).
5
When the machine is in its final position, lower the eight level adjusters,
(4 on the monitor cabinet and 4 on the ride base assy), with a spanner so
that the machine is level and all castors are raised from the floor by
approx. 5mm. Tighten the lock nuts with a spanner to ensure that the level
adjusters do not move.
(4 on the monitor cabinet and 4 on the ride base assy), with a spanner so
that the machine is level and all castors are raised from the floor by
approx. 5mm. Tighten the lock nuts with a spanner to ensure that the level
adjusters do not move.