Namco Bandai Games 90500129 Benutzerhandbuch
50cm or more
50cm or more
2m50cm or more
1m or more
2m50cm or more
50cm or more
50cm or more
Playing Area
Pathway
REMOVING AND REPLACING PARTS
Adjustments or maintenance on this equipment should be carried out by suitably qualified
personnel only.
personnel only.
Do not make any alteration to this equipment without prior approval. Doing so could cause
unforeseeable danger.
unforeseeable danger.
Only parts specified by Namco Europe Ltd. should be used when replacing parts. (Including
screws)
screws)
Ensure that the power to the equipment is turned OFF before commencing any maintenance work.
(Trouble shooting, repairs etc.)
(Trouble shooting, repairs etc.)
If performing work not described in this manual, contact your distributor for instructions, as no
responsibility will be accepted for damage or injury.
responsibility will be accepted for damage or injury.
Parts of the Power Supply and Monitor remain hot and carry high voltage even after switching OFF
and could cause burns or electric shock. Take care not to touch these parts accidentally.
and could cause burns or electric shock. Take care not to touch these parts accidentally.
Make sure that the equipment is switched OFF before connecting or disconnecting any plugs or
connectors.
connectors.
When moving the mains connector from the equipment, or the mains plug from the wall outlet,
always grasp the plug and not the cable.
always grasp the plug and not the cable.
MOVING THE EQUIPMENT
This equipment is fitted with castors to make it easier to move. Take care when moving the
equipment on an inclined surface.
equipment on an inclined surface.
The fitting position of the Header Assembly is high, and it is important that a means of reaching the
height safely, without stretching, is available. (e.g. Steps, Step Stool etc.)
height safely, without stretching, is available. (e.g. Steps, Step Stool etc.)
The overall height of the equipment , with the Header Assembly fitted, is 2080mm. Take care of any
overhead obstructions. (e.g. Light Fittings, Electric Cables etc.
overhead obstructions. (e.g. Light Fittings, Electric Cables etc.
NOTES ON INSTALLATION
NEVER turn the power to the machine ON until installation has been
completed.
completed.
In order to prevent possible electric shocks, be sure that the
equipment is connected to the mains with a securely connected
earthed plug.
equipment is connected to the mains with a securely connected
earthed plug.
So that customers are not injured by the movement of the equipment,
ensure that there is at least 500mm seperation between other
equipment or walls.
ensure that there is at least 500mm seperation between other
equipment or walls.
In order to avoid damage to the equipment due to mis-operation, ensure
that the voltage of the mains supply is 230volts AC.
that the voltage of the mains supply is 230volts AC.
Note:
If the location of this equipment has a polished floor, it is recommended
that rubber pads are fitted under the level adjusters to prevent the
equipment sliding on the floor when in use.
that rubber pads are fitted under the level adjusters to prevent the
equipment sliding on the floor when in use.
Note:
In order to gain access to the Power Supply and CPU assemblies, ensure
that the rear of the equipment is seperated from a wall or other equipment
by at least 500mm
that the rear of the equipment is seperated from a wall or other equipment
by at least 500mm