Kramer Electronics Network Hardware RTBUS-21 Benutzerhandbuch
RTBUS-21 - Installing the RTBUS-21
7
7
5
Installing the RTBUS-21
To install the
RTBUS-21 perform the following steps:
1. Drill a hole in the table (see
Section 5.1
2. Insert the unit
through the hole and secure the unit to the table (see
Section
3. Connect the cables (see
Section 5.3
5.1 Drilling a Hole in the Table
To drill an opening in the table:
1. Using any standard cup bit drill with a diameter ranging from 110mm to
112mm (4.33in to 4.4in), drill a hole in the table in the desired location.
i
The thickness of the table should be 3in (76mm) or less.
2. Clean the table surface.
!
Take care not to damage the table. Kramer Electronics is not
responsible for any damage caused to the table.
responsible for any damage caused to the table.