Kenwood TM-271 Benutzerhandbuch
9
3
GETTING ACQUAINTED
FRONT PANEL
Note: This section describes only the main functions of the front
panel controls. Explanations for functions not described here are
provided in the appropriate sections of this instruction manual.
panel controls. Explanations for functions not described here are
provided in the appropriate sections of this instruction manual.
q
w
e
r
t
y
u
TM-271
MENU
q
q
q
q
q
(Power) switch/ Volume control
Press to switch the transceiver power ON or OFF
{page 14}.
{page 14}.
Turn to adjust the level of the receive audio from the
speaker {page 14}.
speaker {page 14}.
w
w
w
w
w MENU button/ Tuning control
Press to enter MHz Mode {page 16}. In this mode,
you can change the operating frequency in 1 MHz
steps using the Tuning control or Mic [UP]/[DWN].
Press and hold for 1 second while in VFO Mode to
begin MHz Scan {page 41} or while in MR Mode to
begin Group Scan {page 42}.
you can change the operating frequency in 1 MHz
steps using the Tuning control or Mic [UP]/[DWN].
Press and hold for 1 second while in VFO Mode to
begin MHz Scan {page 41} or while in MR Mode to
begin Group Scan {page 42}.
Press [F] then press [MENU] to enter Menu Mode
{page 18}.
{page 18}.
Turn to select:
• Operating frequencies when in VFO Mode {page 15}.
• Memory Channels when in Memory Recall Mode
• Memory Channels when in Memory Recall Mode
{page 30}.
• Menu Nos. when in Menu Mode {page 18}.
• Scan direction while scanning {pages 27, 39, 47, 49}.
• Scan direction while scanning {pages 27, 39, 47, 49}.
e
e
e
e
e CALL key
Press to recall the Call Channel {page 35}. Press
and hold for 1 second while in VFO Mode to begin
Call/VFO Scan {page 43}. Press and hold for
1 second while in Memory Recall Mode to begin Call/
Memory Scan {page 43}.
and hold for 1 second while in VFO Mode to begin
Call/VFO Scan {page 43}. Press and hold for
1 second while in Memory Recall Mode to begin Call/
Memory Scan {page 43}.
Press [F] then press [CALL] to activate the Tone
{page 24}, CTCSS {page 46}, or DCS {page 48}
function.
{page 24}, CTCSS {page 46}, or DCS {page 48}
function.
r
r
r
r
r VFO key
Press to enter VFO Mode {page 15}. In this mode,
you can change the operating frequency using the
Tuning control or Mic [UP]/[DWN]. Press and hold
for 1 second while in VFO Mode to begin Band Scan
{page 40}. Press and hold for 1 second while in VFO
Mode after programming a scan range to begin
Program Scan {page 40}.
you can change the operating frequency using the
Tuning control or Mic [UP]/[DWN]. Press and hold
for 1 second while in VFO Mode to begin Band Scan
{page 40}. Press and hold for 1 second while in VFO
Mode after programming a scan range to begin
Program Scan {page 40}.