Juniper Networks T1600 Benutzerhandbuch

ge-7/0/5 up down
ge-7/0/6 up down
ge-7/0/7 up up
bcm0 up up
bcm0.0 up up inet 10.0.0.4/8
inet6 fe80::200:ff:fe00:4/64
fec0::a:0:0:4/64
tnp 4
dsc up up
em0 up up
em0.0 up up inet 10.0.0.4/8
inet6 fe80::200:1ff:fe00:4/64
fec0::a:0:0:4/64
tnp 4
fxp0 up up
fxp0.0 up up inet 192.168.168.34/22
gre up up
ipip up up
lo0 up up
lo0.0 up up inet 10.255.168.34 --> 0/0
127.0.0.1 --> 0/0
iso 47.0005.80ff.f800.0000.0108.0001.0102.5516.8034
inet6 abcd::10:255:168:34
fe80::2a0:a5ff:fe5e:59f5
lo0.16384 up up inet 127.0.0.1 --> 0/0
lo0.16385 up up inet
lsi up up
mtun up up
pimd up up
pime up up
tap up up

After you have verified operation, you can install T1600-FPC4s.

Removing the Upper Front Fan Tray

NOTE: Remove the front upper fan tray to make the craft interface easier to replace
and to avoid injury and damaging the equipment.

The upper front fan tray is located above the FPC card cage. The fan tray weighs
about 18.6 lb (8.4 kg). To remove the upper front fan tray, follow this procedure (see
Figure 21 on page 40):

Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and
connect the strap to one of the ESD points on the chassis. See “Preventing
Electrostatic Discharge Damage” on page 47.

Loosen the captive screws on the corners of the fan tray faceplate.

Grasp the handles and pull the fan tray halfway out of the chassis.

Removing the Upper Front Fan Tray

■

Removing the Upper Front Fan Tray