Juniper Networks T1600 Benutzerhandbuch
Preventing Electrostatic Discharge Damage
Many T1600 routing node hardware components are sensitive to damage from static
electricity. Some components can be impaired by voltages as low as 30 V. You can
easily generate potentially damaging static voltages whenever you handle plastic or
foam packing material or if you move components across plastic or carpets. Observe
the following guidelines to minimize the potential for electrostatic discharge (ESD)
damage, which can cause intermittent or complete component failures:
electricity. Some components can be impaired by voltages as low as 30 V. You can
easily generate potentially damaging static voltages whenever you handle plastic or
foam packing material or if you move components across plastic or carpets. Observe
the following guidelines to minimize the potential for electrostatic discharge (ESD)
damage, which can cause intermittent or complete component failures:
■
Always use an ESD wrist strap or ankle strap, and verify that it is in direct contact
with your skin.
with your skin.
CAUTION: For safety, periodically check the resistance value of the ESD strap. The
measurement should be in the range of 1 to 10 Mohms.
measurement should be in the range of 1 to 10 Mohms.
■
When handling any component that is removed from the chassis, verify that the
equipment end of your ESD strap is attached to one of the ESD points on the
chassis, which are shown in Figure 1 on page 4 and Figure 2 on page 5.
equipment end of your ESD strap is attached to one of the ESD points on the
chassis, which are shown in Figure 1 on page 4 and Figure 2 on page 5.
■
Avoid contact between the component and your clothing. ESD voltages emitted
from clothing can still damage components.
from clothing can still damage components.
■
When removing or installing a component, always place it component-side up
on an antistatic surface, in an antistatic card rack, or in an electrostatic bag (see
Figure 26 on page 47). If you are returning a component, place it in an
electrostatic bag before packing it.
on an antistatic surface, in an antistatic card rack, or in an electrostatic bag (see
Figure 26 on page 47). If you are returning a component, place it in an
electrostatic bag before packing it.
Figure 26: Placing a Component into an Electrostatic Bag
Preventing Electrostatic Discharge Damage
■
47
Preventing Electrostatic Discharge Damage