K-Tec MT2000 Benutzerhandbuch
2 MT2000-0200-01 Rev f (10-2007)
DCN0160
TABLE OF CONTENTS
1. INTRODUCTION ................................................................................................................ 4
2. OVERVIEW ........................................................................................................................ 5
2. OVERVIEW ........................................................................................................................ 5
2.1 Storage Information
.........................................................................................................................
5
2.2 Ambient Temperature
.....................................................................................................................
5
2.3 Description & Principle of Operation
............................................................................................
5
2.3.1 Direct Reflect Mode (standard) ..........................................................................................
5
2.3.2 Ultra Low Dielectric (ULD) Measure Method
......................................................... 6
3. INSTALLATION .................................................................................................................. 7
3.1 Mounting Requirements
............................................................................................. 7
3.2 Shortening of Probe
.................................................................................................. 8
3.3 MT2000 Guided Wave Radar Guidelines ............................................................................
8
3.4 Wiring
...................................................................................................................... 9
3.5 ATEX Approval Information
........................................................................................ 9
4. COMMISSIONING
.............................................................................................................. 9
4.1 Quickstart Procedure
................................................................................................. 9
4.2 Verify Proper Power-Up
........................................................................................... 10
4.3 Setting the 4mA and 20mA Points Using the Pushbutton Menu
................................... 10
4.3.1 LCD Menu Operation
..................................................................................... 11
4.4 Detailed Configuration Parameters
........................................................................... 12
4.4.1 Direct Mode Blanking Parameter (BLK)
.............................................................. 12
4.4.2 Threshold Level Parameter (THV) and Gain Setting (GS)
...................................... 12
4.4.3 Advanced Parameter Settings
......................................................................... 13
4.4.4 Ultra Low Dielectric (ULD) Mode Configuration
.................................................... 15
4.5 Advanced Output Configuration
................................................................................ 16
4.5.1 DAC Trim
.................................................................................................... 16
4.5.2 Setting the DAC Trim
..................................................................................... 16
4.5.3 Displayed Engineering Units (EUN)
................................................................... 16
4.5.4 4 - 20 mA Output Damping (DMP)
.................................................................... 16
4.5.5 Bench Calibration of the 4mA & 20mA Points
...................................................... 17
4.5.6 4mA & 20mA Calibration Using Actual Level Input
............................................... 17
4.5.7 Reversing the Output Action Using Actual Level Input
........................................... 18
4.5.8 Jumper Switch Settings
.................................................................................. 18
5. TROUBLESHOOTING INFORMATION ........................................................................... 19
5.1 Valid Current Loop Outputs
...................................................................................... 19
5.2 Possible Symptoms
................................................................................................. 19
5.3 Electronics Module Replacement
.............................................................................. 20
6. HONEYWELL DE OUTPUT OPTION ............................................................................... 20
6.1 Interoperability and Conformance Class
.................................................................... 20
6.2 Operating Modes
..................................................................................................... 21
7. HART PROTOCOL INTERFACE OPTION ....................................................................... 21
7.1 268 ROSEMOUNT Communicator
............................................................................ 21
7.2 HART AMS
............................................................................................................. 21
7.2.1 Compatibility
................................................................................................ 21
7.2.2 Resource Files
............................................................................................. 21
8. GLOSSARY OF TERMS .................................................................................................. 22