Jotul GI 425 DV Benutzerhandbuch

Use Jøtul Thermostat #129706 or a 750 millivolt DC
two-wire circuit thermostat to automatically control
your fireplace operation. The thermostat should be
placed in the same room as the heater, typically 5’ off
the floor.  Avoid drafty areas or any area that may
affect the accuracy of the thermostat.

The thermostat should be connected to the

GI425 using a minimum of 16 gauge wire with  a
maximum length of 35 feet of wire.

Connect the two thermostat wire leads to the

two lower terminals on the terminal block located to
the right of the ON/OFF/T’STAT switch. Do not
overtighten the connections.  IT IS NOT NECESSARY
TO DISCONNECT ANY OTHER WIRES. See Figure 16.

At the thermostat, the two wires should be

connected to the two connections screw on the
thermostat base plate per the manufacturer’s
instructions.

For thermostatic function, place the ON/OFF/T-STAT

switch in the T-STAT position and the pilot flame
must be lit.

The optional Jøtul Remote Control  can be installed
on the GI425 gas fireplace.  Using the wire supplied
with the remote, connect the remote directly to the
gas control valve.

 Connect one receiver lead to the terminal

labelled TH.  Connect the other receiver lead to the
terminal labeled TH/TP.  DO NOT DISCONNECT ANY
OTHER WIRES FROM THE VALVE, AND DO NOT OVER
TIGHTEN THE TERMINAL SCREWS.

Place the receiver unit under the control valve

on the floor of the fireplace cabinet.

CAUTION:

LABEL ALL WIRES PRIOR TO DIS-

CONNECTION WHEN SERVICING

THE CONTROLS.  WIRING ERRORS

CAN CAUSE IMPROPER AND DAN-

GEROUS OPERATION.  ALWAYS

VERIFY PROPER OPERATION AFTER

SERVICING THE APPLIANCE.

ATTENTION:

AU MOMENT DE L’ENTRETIENDES

COMMANDES, ETIQUETEZ TOUS LES

FILS AVANT LE DEBRANCHEMENT.

DES ERREURS DE CABLAGE

PEUVENT ENTRAIUN

FONCTIONNEMENT INADEQUAT ET

DAGEREUX.

ON

OFF

STAT

TH

TP
TH

TP