John Deere Products & Services OMGX20927 Benutzerhandbuch
Service - 13
SERVICE
Service
Adjusting Bagger Level
NOTE: Prior to adjusting bags for level, check machine
for level: proper tire inflation and parked on a level
surface.
for level: proper tire inflation and parked on a level
surface.
M96100
1. Install left and right bags on mounting post (A).
2. Adjust left and right bags for level:
•
Adjust for front-to-rear level, by bending tab (B).
•
Adjust for side-to-side level, by bending tab (C).
Adjusting Hood Hold-Down
NOTE: Prior to adjusting hood hold-down, make sure
bags are level.
bags are level.
MX10308
1. Close hopper top and fasten hood hold-down (B) over
latch rod (A).
latch rod (A).
2. Hood hold-down should stretch down 19-25 mm (3/4-1
in.) to be fastened. If it does not stretch, adjust latch rod.
in.) to be fastened. If it does not stretch, adjust latch rod.
M96098a
3. Adjust latch rod:
•
Remove lock nut (D), flat washer (E) and cap screw
(G).
•
Add additional flat washer (C) between latch rod (F)
and bag mounting bracket.
•
Install and tighten cap screw (G), flat washer (E) and
lock nut (D).
Adjusting Hopper Top Hinge Tightness
NOTE: Prior to adjusting hopper top hinge tightness,
make sure bags are level.
make sure bags are level.
1. With bags installed, fully raise and lower hopper top
several times.
several times.
c
CAUTION: Avoid injury! To prevent injury from
thrown objects, do not open catcher while
blades are turning.
blades are turning.
IMPORTANT: Avoid damage! Bag frames must be
level horizontally or hopper top will not seal
properly.
level horizontally or hopper top will not seal
properly.
c
CAUTION: Avoid injury! To prevent injury from
thrown objects, do not open catcher while
blades are turning.
blades are turning.
A
B
C
c
CAUTION: Avoid injury! To prevent injury from
thrown objects, do not open catcher while
blades are turning.
blades are turning.
B
A
G
C
E
D
F