Jenn-Air Built-in Coffee System JBC7624BS Benutzerhandbuch

6. “TURNING OFF Please wait...” will be displayed. The coffee 

system will turn off.

7. Slide the coffee system forward using the handles as shown 

in the following illustration.

8. Open the coffee bean container lid, fill the coffee bean 

container with coffee beans and close the lid.
IMPORTANT: Do not place ground coffee, freeze-dried 
coffee, caramelized coffee or foreign objects into the coffee 
bean container, as they could damage the machine.

9. Push the coffee system back into the housing. It is now ready 

for normal use.

NOTE: When first using the coffee system, you need to make 4-5 
cups of coffee and 4-5 cappuccinos before the coffee system 
gives good results.
NOTE: Each time the machine is turned on using the main On/Off 
switch, it runs a self-diagnosis function and then goes into 
standby mode. To turn the machine on again, press the On/
Standby button to the left of the coffee spout. See the illustration 
in the “Parts and Features” section.

COFFEE SYSTEM USE

You can control several settings through the Settings Menu: 
Rinsing, Beep, Statistics, Default Values, Water Hardness,
Auto-Off, Coffee Temperature, Descaling, Auto-Start, Language 
and Adjust Time.
To access the Settings Menu, press MENU. To exit the Settings 
Menu, press MENU again.

This function is used to rinse the coffee spout or preheat the 
brewing unit if more than 2 minutes have passed since the 
machine was last preheated. Hot water from the rinse cycle can 
be used to preheat a small cup of coffee. 
1. Press MENU.
2. Press the up and down arrow keys until “RINSING” is 

displayed. Press OK.

3. “OK to confirm” will be displayed. Press OK.
4. “Please wait...” and a progress bar will be displayed. 1 oz 

(30 mL) of hot water will run into the drip tray. 
NOTE: If desired, you can place a small cup beneath the 
coffee spout. The hot water will warm the cup. Empty the hot 
water before using the cup for coffee.

The coffee system is factory-set with tones enabled, but they can 
be disabled.
1. Press MENU.
2. Press the up and down arrow keys until “BEEP Enabled” is 

displayed. Press OK.

3. “BEEP Disable?” will be displayed. Press OK to deactivate the 

tones.

4. Press MENU to exit the menu.
To reactivate the tones, repeat steps 1-4.

This function allows you to view the machine statistics.
1. Press MENU.
2. Press the up and down arrow keys until “STATISTICS” is 

displayed. Press OK.

A

A

A

A

B

C

D

E

G

H

I

J

K

F