Jenn-Air ELECTRIC WARMING Benutzerhandbuch

• Be sure appliance is off and all parts

are cool before handling or cleaning.
This is to avoid damage and possible
burns.

• The control knobs may be removed for

easier cleaning.

• Before removing

the knobs for
cleaning, make
sure they are in
the vertical position.

• Wash the knobs in soap and water but

do not soak.

• Dry and replace the knobs.

* Brand names for cleaning products are registered trademarks of the respective manufacturers.
** To order direct, call 1-800-JENNAIR.

Most cleaning can be done to the pan with
the pan in place in the drawer. However,
the pan may be removed if further cleaning
is needed.

• Open the drawer fully.

• Using the finger grasp holds on the side of

the drawer, lift the pan up and out.

• Use soap and warm water to thoroughly

clean. Rinse and dry.

• Clean the rack with soap and water.

• After cleaning, rinse the rack with clean

water and dry with a clean cloth.

• Do not use a steel wool pad; it will

scratch the surface.

• Clean with hot soapy water. Rinse and

dry.

• If food soil remains, try a general kitchen

cleaner, such as Fantastik

®

, Simple Green

®

or Formula 409

®

*.

• For hard to clean soil use a standard

stainless steel cleaner such as Bon-Ami

®

or Cameo

®*

. Soils can also be soaked

several hours with wet towels. Apply
cleaner with a damp sponge, rinse thor-
oughly and dry. Always scrub lightly in
the direction of the grain. After cleaning,
use a stainless steel polish such as Stain-
less Steel Magic

®

**.

• A fuse in your home may be blown or the

circuit breaker tripped. Replace the fuse
or reset the circuit breaker.

• Check to see if the Warming Drawer is

plugged in.

• Controls improperly set. See the Using

the warming drawer section, pgs. 3-5.

Drawer does not slide smoothly  or
drags.

• Ball bearings may be out of alignment.

Fully extend the drawer and push it all
the way in. See the Care and Cleaning
section.

• Drawer over-loaded or the load is unbal-

anced. Reduce weight to less than 50
pounds. Redistribute drawer contents.

• There may be liquid in the warming

drawer pan. Remove liquid.

• Cover food with lid or aluminum foil.

• Temperature setting is too high. Reduce

the temperature setting.

• Incorrect Moisture Selector setting. Set

the Moisture Selector to the open vent
setting to allow venting.

• Room temperature may prevent the ther-

mostat from tripping on. Turn the knob
to LOW then back to PROOF.

• Moisture is escaping. Cover food with lid

or aluminum foil.