MGE UPS Systems Network Shutdown Module V3 Benutzerhandbuch
www.apc.com
/
www.mgeups.com
T H E U N I N T E R R U P T I B L E P O W E R P R O V I D E R
Network Shutdown Module V3 – User Manual - APC # 990-3630 (MGE # 34 003 934 XU / AB)
Page 9/66
2
Installation
Note: This user manual only applies to Network Shutdown Module V3. For previous versions of Network
Shutdown Module V2.x, please read the HTML on line manual.
Shutdown Module V2.x, please read the HTML on line manual.
2.1 Hardware
Pre-requisites
(Electrical and Network Connections)
Connection steps
Before connecting the UPS, you must first decide on a
software and hardware architecture
.
Before installing the MGE Network Solution, the UPS must be set up as indicated in the steps below.
ω
Shut down the computers to be protected by the UPS.
ω
Connect the UPS to a wall outlet. (For UPSs above 3kVA, please refer to the UPS installation manual).
ω
Connect the power cord of each computer to an outlet on the UPS. (For UPSs above 3kVA, please refer
to the UPS installation manual).
to the UPS installation manual).
ω
How to connect UPS / proxy or card / network:
>
If the Mgt. Proxy is used, connect the serial or USB port on the computer and on the UPS.
>
If a Network Management Card is used, insert the optional card in the UPS and connect the UPS to
the computer network.
the computer network.
ω
Start the MGE UPS, then the computers.
ω
Setting up the protection
>
If the Mgt. Proxy is used install it on the one machine directly connected to the UPS.
>
If a Network Management Card is used, it must be set up (see the Mgt. Card's user manual).
ω
Install Network Shutdown Module on all the other machines that are to be protected by the UPS (supplied
with UPS battery backup power).
Note: The Mgt. Proxy manages protection of the machine on which it is installed.
with UPS battery backup power).
Note: The Mgt. Proxy manages protection of the machine on which it is installed.