McIntosh MDLP1 Benutzerhandbuch

How to Connect the MDLP1

The MDLP1 has the ability to automatically switch power

On/Off to McIntosh Components via the Power Control

and Trigger Connections. The Data Port Connections allow

for the remote operation of the MDLP1 from other McIn-

tosh Components. With an external sensor connected to

the MDLP1, remote control operation is possible when the

MDLP1 is located in an enclosure.

The connection instructions below, together with the

AP1000/MDLP1/VP1000 Input and Control Connection

Diagrams located on the separate folded sheet “Mc2A and

Mc2B”, are an example of a typical audio/video system.

Your system may vary from this; however, the actual com-

ponents would be connected in a similar manner.

For additional information refer to “Connector and

Cable Information” on page 6.

Note: With the addition of a McIntosh Power Controller

connected to the MDLP1,

AC Power Switching can

be provided to components such as a motorized

projection screen.

Contact your McIntosh Dealer for

additional information.

Power Control Connections:

1. Connect a Control Cable from the MDLP1 POWER

CONTROL IN Jack to the Power Control Out A Jack

on the McIntosh VP1000 Video Processor.

If the MDLP1 is connected to a McIntosh Audio/Video

Control Center MX136, MX135, MX120, MX119, MX134

or MX132 (MX Series) add the following connection:

2. Connect a Control Cable from the MDLP1 POWER

CONTROL IN A Jack to the McIntosh MX Series

Power Control Zone A Out Jack.

Data Control Connections:

When the MDLP1 is connected to the McIntosh VP1000

Video Processor no Data Port connection is necessary.

If the MDLP1 is connected to a McIntosh Audio/Video

Control Center MX136, MX135, MX120, MX119, MX134

or MX132 (MX Series) add the following connection:

3. Connect a Control Cable from the MDLP1 DATA IN

Jack to the McIntosh MX Series SUM A Data Port

Jack.

Video Connections:

When the MDLP1 is connected to the McIntosh VP1000

Video Processor add the following connections. If there is

no VP1000 proceed to step 6.

4. Connect a Video Cable from the MDLP1 Y1, PB1 and

PR1 COMPONENT VIDEO Input Jacks to the McIn-

tosh VP1000 Component Video MON A Jacks.

5. Connect a Video Cable from the MDLP1 HDMI 1

Input Jack to the McIntosh VP1000 HDMI MON A

Output Jack.

If the MDLP1 is connected to a McIntosh Audio/Video

Control Center MX136, MX135, MX120, MX119, or

MX134 (MX Series) add the following connection:

6. Connect a Video Cable from the MDLP1 Y1, PB1 and

PR1 COMPONENT VIDEO Input Jacks to the McIn-

tosh MX Series Component Video MON A Jacks.

7. Connect a Video Cable from the MDLP1 HDMI 1

Input Jack to the McIntosh MX Series HDMI MON A

Output Jack.

Note: Only the MX136 and MX120

Audio/Video Con-

trol Centers

will have a HDMI MON A Jack.

AC Power Cord Connections:

8. Connect the MDLP1 AC Power Cord to a live AC

outlet.

9. Connect the remaining components’ AC Power Cords.