McIntosh MDLP1 Benutzerhandbuch

9

For the best possible image reproduction by the McIntosh 

MDLP1 Video Projector, it is important to observe the fol-

lowing:

CAUTION: The MDLP1 Video Projector weight 

is 40 pounds (18.14 kilograms). When 

mounting the projector to a building 

structure it is important to follow all of 

the local building/constuction codes.

1. Decide on a viewing area with either subdued and/

or controlled ambient lighting.

2. Choose a projector screen designed specifically to 

work with images from a DLP Projector.

3. Locate the position of the MDLP1 Projector rela-

tive to the projector screen to maximize image 

quality and minimize optical distortions.

4. Provide adequate ventilation.

The information below and on the following pages will as-

sist in the location of the Projector. It is recommended that 

the Professionals at your McIntosh Dealer, who are skilled 

in all aspects of installation and operation, install the 

MDLP1 Video Projector and any associated audio/video 

equipment.

Always provide adequate ventilation for your MDLP1. 

Cool operation ensures the longest possible operating life 

for any electronic instrument. Do not install the MDLP1 

directly above a heat generating component. Refer to fig-

ures 1 and 2.

The MDLP1 is designed to be placed upright on a solid 

flat surface, resting on its three feet with unrestricted air 

flow around it. Allow at least 1 foot (30.48 cm) of space 

between the Primary Warm Air Exit ventilation holes and 

the nearest wall or obstruction. There should be at least 

3 inches (7.62 cm) between the Primary Cool Air Input 

ventilation holes and the nearest wall or obstruction. The 

ambient air temperature should not exceed 95°F (35°C).

The projector uses two primary and three secondary 

cool air input vents together with one primary warm air 

exit vent. Refer to the illustration on this page. The air flow 

in or out of these vents needs to be unrestricted at all times 

during operation.

In the event the MDLP1 is to be placed into an enclo-

sure restricting air flow around the projector, some type of 

ducted forced air venting system would need to be imple-

mented for the primary input 1 and 2 vents along with the 

primary exit vent.

Primary

Cool Air

Input No. 2

Primary

Cool Air

Input No. 1

Secondary Cool Air

Input No. 3

Secondary Cool Air

Input No. 1

Primary

Warm Air

Exit

Secondary Cool Air

Input No. 2

Figure 1

Figure 2