McCulloch M195-42T Benutzeranleitung

Seite von 60
6
Fig. 1
Fig. 2
ASSEMBLY
TO CHECK BATTERY (See Fig. 1)
•  Lift seat to raised position.
NOTE: If this battery is put into service after month and 
year indicated on label (label is located between terminals) 
charge battery for minimum of one hour at 6-10 amps. 
(See "BATTERY" in Maintenance  section of this manual 
for charging instructions).
•  For battery and battery cable installation see "RE-
PLACING BATTERY" in the "Service and Adjustments" 
section in this manual.
LABEL
TO REMOVE TRACTOR FROM CARTON
UNPACK CARTON
•  Remove all accessible loose parts and parts cartons  
from carton.
•  Remove end panels and lay side panels flat.
•  Check for any additional loose parts or cartons and 
remove.
BEFORE REMOVING TRACTOR FROM 
SKID
TO INSTALL STEERING WHEEL (See Fig. 2)
ASSEMBLE EXTENSION SHAFT AND BOOT
•  Slide extension shaft onto lower steering shaft.  
•  Place tabs of steering boot over tab slots in dash and 
push down to secure.
INSTALL STEERING WHEEL
• 
Position front wheels of the tractor so they are pointing 
straight forward.
•  Remove steering wheel adapter from steering wheel 
and slide adapter onto steer ing shaft ex ten sion.
•  Position steering wheel so cross bars are hor i zon tal 
(left to right) and slide inside boot and onto adapt er.
•  Assemble large flat washer, lock washer, hex bolt and 
tighten se cure ly.
• 
Snap steering wheel insert into center of steer ing wheel.
•  Remove protective materials from trac tor hood and 
grill.
IMPORTANT:  CHECK FOR AND REMOVE ANY STAPLES IN 
SKID THAT MAY PUNCTURE TIRES WHERE TRACTOR IS TO 
ROLL OFF SKID.
LOWER
STEERING 
SHAFT
STEERING 
BOOT
EXTENSION 
SHAFT
STEERING 
WHEEL
INSERT
ADAPTER
BOLT
LARGE FLAT 
WASHER
LOCK 
WASHER
Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes.  
To ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely.  Use 
the correct tools as necessary to ensure proper tightness.
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set will make assembly easier.  Stan dard 
wrench sizes are listed.
(1)  5/16" wrench 
 
Utility knife
(2)  7/16" wrenches 
 
Tire pressure gauge
(2)  1/2" wrenches 
 
Pliers
(1) 9/16" wrench
When right or left hand is mentioned in this man ual, it means 
when you are in the operating po si tion (seated be hind the 
steer ing wheel).