Maytag W10190314A Benutzerhandbuch

■

If the compactor is to be midway between “1” and “3,” 
place the retaining bracket mounting screws through “2.”

7. Slowly lift the front slightly and roll compactor into the kitchen 

cabinet opening.

8. Using 2 - #8 - 18 x 

¹
₂" mounting screws (provided in 

conversion kit), fasten the retaining brackets (provided in 
conversion kit) to the countertop with the mounting screws.

NOTE: If retaining brackets cannot be attached to the 
underside of countertop, attach mounting clips (provided in 
conversion kit) to retaining brackets. Fasten compactor to 
kitchen cabinet face with mounting screws through the 
mounting clips.

9. Grasp sides of compactor drawer and place bottom of 

drawer into tracks. Lift at the handle so drawer will go over 
drawer stops. Close drawer. Check to see whether drawer 
opens freely. If the toe plate rubs against floor, see “Adjusting 
the Toe Plate” later in this section, for further instructions.

If the toe plate rubs the floor covering, the toe plate clearance 
may be changed as follows:

1. Mark on each side of the toe plate the amount of toe plate 

that rubs the floor covering.

2. Remove the drawer from the unit. See Step 3 in the 

“Unpacking” section.

3. Use a ruler and a pencil or chalk to draw a line between the 

marks on each side of toe plate.

4. Use scissors or utility knife to cut toe plate along line.

5. Replace drawer. If toe plate still rubs floor covering, repeat 

steps 1-4.

Use these dimensions drawings to create a custom panel for use 
without a trim kit. The panel should be 

¹⁄₂" to ⁵⁄₈" (13 mm to 

16 mm) thick.

NOTE: A thicker panel may need rounded front corners and a 
cutout for access to the handle.

B

A

A

B

C

A

D

C

B