Sharper Image TI150 Benutzerhandbuch
3
10
T
ROUBLESHOOTING
G
UIDE
PROBLEM
POSSIBLE CAUSE
SOLUTION
Unit fails to heat up.
Unit is not plugged in.
Plug into electrical
outlet.
outlet.
Household Circuit Breaker /
Ground Fault Interrupter has
tripped or blown a fuse.
Ground Fault Interrupter has
tripped or blown a fuse.
Reset Circuit Breaker /
Ground Fault Interrupter, or
replace fuse. If you need
assistance, contact a licensed
electrician.
Ground Fault Interrupter, or
replace fuse. If you need
assistance, contact a licensed
electrician.
Unit heats up, but fails to
steam.
steam.
Water Reservoir is empty.
Refill Water Reservoir using
procedures on page 7 of this
manual.
procedures on page 7 of this
manual.
Mineral build-up in unit.
Follow Removing Mineral
Build-Up procedure on page
9 of this manual.
Build-Up procedure on page
9 of this manual.
Steam output is intermittent.
Mineral build-up in unit.
It is normal for unit to
periodically stop steaming
for a few seconds. If steam
stays off for longer periods,
follow Removing Mineral
Build-Up procedure on page
9 of this manual.
periodically stop steaming
for a few seconds. If steam
stays off for longer periods,
follow Removing Mineral
Build-Up procedure on page
9 of this manual.
WARNING: To reduce the risk of fire, electrical shock, or injury,
the following basic safety precautions should always be followed
when using an electrical appliance.
the following basic safety precautions should always be followed
when using an electrical appliance.
READ ALL INSTRUCTIONS BEFORE USING YOUR FABRIC STEAMER
1. DO NOT overfill unit with water. Fill to MAX mark only (7 oz.). Overfilling
may result in burns from spilling water, or possible electrical shock.
2. DO NOT leave your TI150 Wrinkle-Free Steamer unattended when plugged
in or not in use. Use only for its intended purpose as indicated in this manual.
3.
This unit is not a toy. Close supervision is required when using unit
near children, pets, and plants. Steam produced by unit is hot and
pressurized. Care must be taken to avoid burns or other injuries. Never
point nozzle at people or pets.
pressurized. Care must be taken to avoid burns or other injuries. Never
point nozzle at people or pets.
4. To reduce the risk of contact with hot water emitting from steam vents, hold
appliance away from body and check for signs of condensation or leakage.
5. DO NOT use this unit if electrical cord or outlet is damaged. DO NOT use unit if
it is not working properly or has been dropped, damaged or left outdoors. If such
damage occurs, DO NOT disassemble or attempt repairs, take unit to a qualified
service person for examination and repair. Incorrect reassembly or repair could
cause a risk of fire, electrical shock, or injury to persons when steamer is used.
damage occurs, DO NOT disassemble or attempt repairs, take unit to a qualified
service person for examination and repair. Incorrect reassembly or repair could
cause a risk of fire, electrical shock, or injury to persons when steamer is used.
6. To reduce risk of electrical shock, DO NOT immerse in water or other liquids.
DO NOT use electrical cord as a handle. DO NOT allow cord to be crimped by
closing it in doors. DO NOT pull or stretch cord around sharp corners or edges.
closing it in doors. DO NOT pull or stretch cord around sharp corners or edges.
7. Do not allow cord to touch hot surfaces. Let appliance cool completely before
putting away. Loop cord loosely around appliance when storing.
8. DO NOT use this unit with extension cords or electrical outlets that have
inadequate current capacity. A three-prong outlet or a properly grounded adapter
is necessary when using TI150 Wrinkle-Free Steamer.
is necessary when using TI150 Wrinkle-Free Steamer.
IMPORTANT SAFEGUARDS
SAVE THESE INSTRUCTIONS!
FOR HOUSEHOLD USE ONLY