Lightwave Communications SCS3230 Benutzerhandbuch

A Lantronix Company  

 

SCS3230 System Administrator's Guide  

15.00.038

 

 - 63 - 

May 2002 

 
To delete a user, use the 

DELETEUSER command, followed by the user ID on the same 

line.  The 

LISTUSERS command will allow verification after deleting a user ID.  The 

following command sequence is an example of the use of 

DELETEUSER with 

LISTUSERS: 
 

 
sys admin>>DELETEUSER PETE 
Delete user:pete                 Yes or No (N):y 
 
sys admin>>listusers 
2: User id > KEVIN 
3: User id > TONY 
 
sys admin>> 
 

 

User IDs may also be deleted by their record number.  As each user ID is created, it is assigned 
a sequential record number.  This number is associated with the user ID and will be displayed 
using the 

LISTUSER command. 

 

 
sys admin>> deleteuser /3 
Delete user:tony                 Yes or No (N):y 
 
sys admin>> 
 
 

 
To delete a user ID using the record number, specify the number as a qualifier after the 
DELETEUSER command in the form DELETEUSER /N, where N is the user record number. 
 

 
Device port parameters must be defined by the sys admin using the 

DEVICES 

command.  If a single device port is to be changed, the port number must follow the 
DEVICES command.  If the DEVICES command is entered by itself, the configuration of 
all device ports will be listed.  To edit all possible device ports for a unit, enter the 
command 

DEVICES /ALL. 

 
Programmable elements include: device name, baud rate, stop bits, parity, data bits, 
DCE/DTE, flow control and inhibit direct mode.  Pressing 

<ENTER> accepts the 

parameter as is.  If changes need to be made, each parameter may be edited as it 
comes up after each 

> prompt. 

 
The device name may not contain the 

* character.  If a name is entered with this 

character, the administrator will be asked to re-enter the name.