Lemur Monitors Jazzmutant Lemur Benutzerhandbuch
The Lemur User Manual
65
The resulting Fader Object looks like this:
Behavior Properties
Capture
If Capture is checked, an Object will only react to cursors that were created
inside its area. Even if the cursor later leaves the Object for another position,
it will remain in control of the original Object, until it is destroyed eventually.
When Capture is off, the old school way from previous versions is restored,
meaning an Object will react to whatever cursor is present at any moment in
its area.
inside its area. Even if the cursor later leaves the Object for another position,
it will remain in control of the original Object, until it is destroyed eventually.
When Capture is off, the old school way from previous versions is restored,
meaning an Object will react to whatever cursor is present at any moment in
its area.
Cursor Mode
If set to
Limited
, the Fader will respond to a new cursor only if the original
one has been destroyed (i.e. finger is raised)
Get Newer
means that whenever a new cursor appears inside the
Object’s area, it gains full control of the Object
In
Barycentric
mode each cursor, old and new, has the same amount of
influence on the Object
In
Cap Only
mode, the Object acts like a conventional fader that doesn’t
react to cursors outside of the cap area
Physics
Can be one of three settings: None, Interpolate, or Mass-Spring.
If Physics is set to
None
, the Fader cap tracks one finger immediately. If
other fingers touch the fader, they are ignored.