Lanier 2001 Benutzerhandbuch
Class 1 Fax/Modem
PC Printing & Scanning
5 - 23
Connecting Class 1 to Your PC
The 2002 uses a standard RS-232C port to communicate with the PC. A serial cable comes
with the 2002 unit. Follow the instructions in “Attaching the Peripheral Cables” on page
2-4 to connect the cable if you have not already connected it.
with the 2002 unit. Follow the instructions in “Attaching the Peripheral Cables” on page
2-4 to connect the cable if you have not already connected it.
Please Note: This feature is optional on your unit.
Installing the PC-Fax Software
There are a number of settings that affect the modem. This table provides a list of common
settings and the preferred Lanier settings.
settings and the preferred Lanier settings.
Using Class 1 Mode
Note these considerations when using Class 1 mode:
•
When your unit communicates with the computer, “CLASS 1 MODE” appears
on the LCD.
•
No other fax activities can be performed while the MFD communicates with the
PC.
•
During a fax operation initiated by your unit, a fax request initiated by the PC is
not processed.
•
The maximum fax transmission speed is 14,400 bps in Class 1 mode.
Modem type
Generic Class 1 or Class 1
Flow control
Xon/Xoff
Dial type
Use the type that matches your telephone service. This
selection determines whether the dial command is
ATDT for tone or ATDP for pulse.
selection determines whether the dial command is
ATDT for tone or ATDP for pulse.
Dial tone detect
OFF
Detect busy
OFF. Your unit detects a busy signal and provides the
correct response. If the remote unit does not answer,
the fax unit responds “No carrier” on the computer,
which can then schedule a re-dial.
correct response. If the remote unit does not answer,
the fax unit responds “No carrier” on the computer,
which can then schedule a re-dial.
Speaker On/Off and volume
OFF