Lantronix UBox 2100 Benutzerhandbuch

Seite von 79
B:Compliance – UBox 4100 
UBox User Guide 
72 
Translation: 
This is a Class B product based on the standard of the Voluntary Control Council for 
Interference from Information Technology Equipment (VCCI). If this is used near a 
radio or television receiver in a domestic environment, it may cause radio 
interference. Install and use the equipment according to the instruction manual. 
Australia/New Zealand
 
This device complies with AS/NZS 3548 Class B limits for the operation of 
Information Technology Equipment. 
Disclaimer and Supplementary Information 
The Lantronix UBox USB Server, Model UBox 4100, complies with Part 15 of FCC 
Rules. Operation is subject to the following two conditions:  
(1) This device may not cause harmful interference, and  
(2) This device must accept any interference received, including interference that 
may cause undesired operation. 
Caution:
  Changes or modifications to the UBox USB Device Server not 
expressly approved by Lantronix could void the user's authority to operate this 
equipment. 
Note:  
This equipment has been tested and found to comply with the limits for a 
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are 
designed to provide reasonable protection against harmful interference in a 
residential installation. This equipment generates, uses, and can radiate radio 
frequency energy, and, if not installed and used in accordance with the instructions, 
may cause harmful interference to radio communications. However, there is no 
guarantee that interference will not occur in a particular installation. If this equipment 
does cause harmful interference to radio or television reception, which can be 
determined by turning the equipment off and on, the user is encouraged to try to 
correct the interference by one or more of the following measures: 
‹ 
Reorient or relocate the receiving antenna. 
‹ 
Increase the separation between the equipment and receiver. 
‹ 
Connect the equipment into an outlet on a circuit different from that to which 
the receiver is connected. 
‹ 
Consult Lantronix or an experienced radio/TV technician for help.