Infocus PN-L702B Benutzerhandbuch

Page 13

INF7020 Hardware Guide

Before following these instructions, your monitor must be wall mounted or attached to a stand or cart which meets 

or exceeds the safety requirements for this monitor and follows all manufacturer safety precautions and instructions.

After mounting the INF7020 monitor, carefully remove all orange tape. 

 

1) 

Center the camera along the top edge of the monitor, aligning the camera bracket with the screw hole on the back of the moni-
tor.

2) 

Securely attach the camera bracket to the monitor using the provided screw.

3) 

Plug the USB cable into an available USB slot on the computer module. 

 It is not necessary to unwrap the cable. It has 

been pre-measured.

4) 

Remove the plastic film from the camera lens.

5) 

Manually tilt and pan the camera (+/40°) as desired. 

1) 

Attach the two antennas into the computer module on the back of the monitor by turning the antennas clockwise until secure.

2) 

Adjust the angle of the antennas as needed to maximize wireless signal strength.

Refer to the Sound Bar user documentation.